Craft: Sticky Bow Wreath
What You'll Need:
Half Polystyrene Ring (I bought a 30cm diameter ring)
Various Colours of Sticky Bows
Hot Glue Gun & Glue
Command Strips
First, empty out all of your sticky bows and separate them into piles of colours and sizes, then you can start placing them onto your polystyrene ring to see how they will sit and if they look good in those positions. Once you're happy with the few you've tested, remove them one by one and add some hot glue to the backs before replacing them back onto the polystyrene ring.
The rings look nice from the beginning, even with white polystyrene still on show!
We started to see a pattern in our positioning which made it easier to figure out which colour went next.
This is how far we managed to get before running out of the bigger green sticky bows so we had to stop here until we could get out and buy a FIFTH bag of sticky bows!
We were so close to finishing it!
Once we finally got more sticky bows and finished off the wreath, we added a couple of Command Strips to the back of the polystyrene ring so it was ready to be displayed on an internal door.
Comments
Post a Comment